This power source is suitable for building intercom and access control of various entrance. When there is electricity, it will normally supply DC 12V current; when the power goes out, it will be continue to provide DC power through lithium battery.
*Using high-performance and high-efficiency transformers, which have higher output efficiency, lower heat generation, and lower noise.
*With international and delicate appearance and panel design, its volume is small., so it is suitable for installation in various occasions.
*With a set of unlocked and a set of dry contact signal output, especially suitable for occasions where need to both unlock and open the automatic door, and cooperation with the internal time difference, unlock first then open the door.
*With passive door open signal, which can convenient to unlock the door by various methods.
*Because it has dry contact signal output with delay, this power supply can be used as a gate signal converter for generating delay contact signals.
*With 5s or 10s delay time adjustable for opening the door
*With intelligent charge and discharge management of the power ,charge and discharge light tips,When the battery voltage is too low or nearly full, and enter in slow charging red light with slow flashes, enter in fast charging,the red light will fast flashes, the blue light flashes when discharging.
*If you want to extension power supply working time after power outage, you can add a lithium battery, used with the 211F lithium battery in the album.
5s or 10s
Maximum peak current output
Unlock and open the door Jet lag
Main controller dimensions
Lithium battery dimensions
96(L)*43(W)*55(H)mm (Optional products)