The door is suitable for installation in workshops, garages, passages and other occasions, and is suitable for installation under various environmental conditions. The door adopts chain drive, reasonable structure, low maintenance rate, its normal operation times are more than 20,000 times, and the service life is more than 20 years.The door can be made as a large industrial door with a width of 20 meters and a height of 15 meters, or a differentiated door panel can be customized according to customer needs.
Composed of door panels, chain shafts, guide wheels, upper and lower door seals, etc.:
The door panel is made of polyurethane foam material, the color is optional, the screw is fixed with a non-slip nut to prevent loosening.
It is drawn by the motor, and the door is synchronously driven by the drive shaft. The sprocket is separated from the chain through the chain push and separation device. When the door is driven, a guide device is set to ensure the normal operation of the door. The support steel plate is 3-5mm thick
Large-torque copper core motor, overheating protection device, precise guide rail limit, power greater than 385N.M, operating noise less than 50db. It can also be locked in case of power failure, and can be opened manually. The opening and closing speed is 0.06-0.12m/s, and the service life is 2-3 million times.
The Two sides of the slide rail are equipped with photocell, and when there is an obstacle under the door, it will keep open.
30M wireless remote control, customer can choose button control according to customer requirements
Wind resistance level 11, wind resistance ability 55M/S
EPDM sealing strips are installed on both sides of the guide rail and the door panel
When the power is off, the guide chain of the motor can be pulled, and the motor can be pulled to open and close the door. The manual opening and closing force is 300N—500N
Because there are no hinges and other accessories between the door panels, the door panels are located on the upper side when opened, which is small in size and particularly beautiful
The transmission chain adopts 10A high-strength chain
IP54, power cords are made of galvanized steel pipe and standard connectors
Standard three-button button with emergency stop switch, pull the guide chain manually after power failure, or it can be controlled by remote control
It needs to be checked every 12 months, according to the frequency of use, add 50 to 200ML of oil, open and close the door in an environment without external noise, observe and listen carefully to the operation of the door.
The high-quality polyurethane board, the double-layer structure not only guarantees the heat preservation effect, but also maintains good transparency and lighting effect. The inside and outside are clearly visible (optional)
When the door lintel is larger than 1200MM, you can choose to make one or two small doors on the upper row of doors for people to pass through quickly (optional)
220V 5A 50HZ,The diameter of the motor power supply wire is recommended to be 2.5 square mm, and it is recommended to install a grounding wire
←Previous: No Information
Next: Sectional Transparent Door→