[[TitleIndustry]]

Main points of automatic door maintenance

Date:Nov 26, 2020

Main points of automatic door maintenance

 


Introduction Automatic door refers to a control unit that can recognize the action of a person approaching the door as a door opening signal, open the door through the drive system, and automatically close the door after the person leaves, and control the opening and closing process. The automatic door system configuration refers to


Main points of automatic door maintenance

Automatic door refers to a control unit that can recognize the action of a person approaching the door as a door opening signal, open the door through the drive system, and automatically close the door after the person leaves, and control the opening and closing process. The automatic door system configuration refers to the peripheral auxiliary control devices connected to the automatic door controller, such as door opening signal source, access control system, security device, centralized control, etc., equipped according to the requirements of use. Must be based on the characteristics of the building. Auxiliary control devices are reasonably equipped with personnel composition and building automation system requirements. An important task in daily maintenance of induction automatic doors is cleaning. How to clean induction automatic doors is generally to scrub the glass from the outside to the inside and from top to bottom. The cleaning content includes the paint on the surface of the glass and the window frame. Glue, cement, etc., should be cleaned up with a glass scraper, cleaning ball, solvent, etc. Glass surface cleaning method Spray the glass surface with Bolu cleaning solution, and then use a clean cloth or glass scraper to wipe and clean. The glass scraper is suitable for large area glass. If there is oily place, you can wipe it with slices of onion, so that the fuzzy Bolu can be renewed. You can also use plastic wrap and a damp cloth with detergent. First spray the cleaner on the glass, and then paste the plastic wrap to soften the solidified oil stains. After ten minutes, remove the plastic wrap. Then wipe it with a damp cloth.

 

1. Keep the relative humidity around the automatic door below 75%.

2. When cleaning, wipe the dust on the black sensors on both sides of the door with a dry cloth, otherwise it will malfunction due to reduced sensitivity.

3. During the use of the automatic door, the wind speed should not be higher than 10m/s, and the rotating automatic door should not be higher than 25m/s. Beyond the need to take shelter measures.

4. Effective measures should be taken to keep and cool down to ensure that the ambient temperature is controlled between the best -10% to 40%°C.

5. Pay special attention to the stability of the electric door in use, and control the entire door smoothly during use, so that the automatic door will not be damaged as a whole. In addition, it is necessary to keep the electric door in a relatively dry environment, so as to ensure the safer use of the electric door.

6. In the process of using the electric door, it is necessary to formulate a detailed maintenance plan for the electric door after the installation is in place, so as to facilitate the protection of the electric door according to the plan in actual use.

7. Pay attention to regularly check the circuit condition of the electric door, whether there is a short circuit or short-circuit, so that the continuity of the use of the electric door can be maintained, and it is also of great benefit to the maintenance of the electric door.

8. Regular maintenance is also very important. It is wrong to think that maintenance is not necessary as long as the automatic door can be used. To carry out effective automatic door repair and maintenance, professional repair and maintenance skills are required, and knowledge and technology in the structure, design, and construction of mechanical equipment are also required.


Previous: No Information

Next: How to distinguish between two-wing revolving door and three-wing revolving door?